Autronica Autroprime Specifications download pdf (Page 11)

Mounting Instructions

Installation Handbook, Autroprime Interactive Fire Detection System, 116-P-APRIME-INSTALL/DGB Rev. E, 2011-08-16,

Autronica Fire and Security AS

Page 11

5. Mounting Instructions

 Find the text foils in the relevant language for the panel, and insert

the textfoils in the correct locations (there are two different foils).

Through the small hole near the slot, use a small screwdriver or

similar to slightly bend the edge (approx. 1mm) of each foil until

the edge slips behind the opening of the slot. An overview of all

foils is shown in Appendix 16.1.

 Refer to the relevant mounting procedure below (A, B or C),

consult the drawings and follow the steps.

Step

A) Mounting the Fire Alarm Control Panel

(BS-200 andBS-200L. For information on BS-200M, see chapter 10)

 The cabinet has 3 mounting holes located at the rear. The upper holes are of key-hole-type.

 Insert the 2 upper screws in the wall according to the drawing.

 Open the cabinet’s front door and hang the cabinet onto the screws.

 Insert the lower screw, then tighten all screws.

 Place the 2 batteries inside the cabinet according to the drawing. Fasten them with strips.

 Connect all external cables to the correct terminal points. Refer to chapter 1.1.

Step

B) Mounting the Operator Panel separately outside a cabinet

(Operator Panel BS-210, an integrated part of BS-200)

 The cabinet has 3 mounting holes located at the rear. The upper holes are of key-hole-type.

 Insert the 2 upper screws in the wall according to the drawing.

 Open the cabinet’s front door and hang the cabinet onto the screws.

 Insert the lower screw, then tighten all screws.

 Unscrew the 4 screws which connect the panel to the cabinet’s front door.

 Remove the Operator Panel with its bracket mounted.

 Remove the bracket from the Operator Panel.

 Disconnect the internal cable from the Operator Panel.

 For cosmetic reasons, unscrew the extended nuts from the door bracket (which the Operator

Panel was fastened to), and turn the door bracket inside out, then fasten it to the cabinet’s

door. Note: The maritime panel BS-200M requires the use of a rubber seal (UY-108)

between the door bracket and the cabinet’s front door.

 Plug the holes by the four plastic studs.

 Mount the Operator Panel’s bracket onto the wall.

 Connect all external cables to the correct terminal points. Refer to chapter 9.7 and 9.8

 Place and centre the lower part of the panel onto the lower part of the bracket, then simply

push the upper part of the panel towards the bracket until it snaps on.

Step

C) Mounting all other panels

(Repeater Panel BS-211, Fire Brigade Panel BU-210, Information Panel BV-210)

 Set the correct address (1-9) by means of the Rotary switch located on the rear side of the

panel (refer to Addressing Panels in the next chapter).

 Mount the panel bracket onto the wall.

 Connect all external cables to the correct terminal points. Refer to chapter 1.1.

 Place and centre the lower part of the panel onto the lower part of the bracket, then simply

push the upper part of the panel towards the bracket until it snaps on.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 75 76

Comments to this Manuals

No comments

Autronica Autroprime Specifications Page 11

Comments to this Manuals

Related products and manuals for Fire protection Autronica Autroprime