Autronica BS-320 User's Guide download pdf (Page 103)

Service Commands

Operator's Handbook, AutroSafe Interactive Fire Alarm System, Release 3, ASAFE-FO/FE Rev. I, 2009-02-27,

Autronica Fire and Security AS

Page 101

14.4.1 Events

To be able to analyse system behaviour for service and maintenance

purposes, a number of events are recorded.

The table below gives an overview of these events and the detailed

information that can be shown on the panel’s display, or on a printout.

Event Detailed Information

Fire Alarms

• Date, time and identity of detection zones entering the Fire Alarm state.

Prealarms

• Date, time and identity of detection zones entering the Prealarm state.

Early Warnings

• Date, time and identity of detection zones entering the Early Warning state.

Faults

• Date, time and identity of subject (individual component, group, zone)

issuing a fault warning signal.

Enable/Disable

• Date, time and identity of subject (individual component, group, zone)

entering the disabled state.

• Date, time and identity of subject (individual component, group, zone)

exiting the disabled state.

User Operations

• The date, time and operation zone identity of the operation of push

buttons; RESET and SILENCE ALARMS.

• The date, time and operation zone identity of the operation of;

ALARM_DISABLE, REACTIVATE, RESOUND, INIT, ACTIVATE_ALARM,

ENABLE IMM_ACT, DISABLE_IMM ACT, SET_TIME.

• The date, time and event id (detection zone identity, fault identity etc) of all

operations of ACCEPT.

Tests

• Date, time and identity of all manually initiated tests.

All Events

• All events

Log Setup

• Read parameters, read filter, clear log.

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 131 132

No comments

Autronica BS-320 User's Guide Page 103